| Modification card for: GL 291 FOR ONLINE | Part No.: 161292 |
Print Date: 12-03-02
| Date | Lev. | + |
Description |
| 31/01-96 | 1 |
1st mc. has the same first 9 mod. Levels as 161291 & the same first 20 levels as 161281. Wet racks with PVC rollers. | |
| 27/03-96 | 2 |
+ |
Bottom plates
fastened with 6x50 bolts + star locks. Back plate fastened with three extra screws near film outlet. |
| 27/03-96 | 3 |
Transformer mounted outside the electronic box. | |
| 24/06-96 | 4 |
Repl.pumps
(66167) altered from PTI to Gormann-rupp without diodes + earth wire mounted. |
|
| 02/07-96 | 5 |
New motor 217217. ELVI with a blank housing. | |
| 21/11-96 | 6 |
Spal circ.pumps replaced by IWAKI MD 20R-N | |
| 10/12-96 | 7 |
Wet racks mounted with 14 PVC rollers each. | |
| 15/04-97 | 8 |
New speed PCB with creep speed. 911937 | |
| 03/09-97 | 9 |
Metal covering plates. | |
| 30/03-98 | 10 |
Springs used to hang repl. pumps. | |
| 30/03-98 | 11 |
Motor changed to 217216. Drive gear wheel mounted with new six sided (217305) cast hub using a wedge on the drive motor. | |
| 30/03-98 | 12 |
New Fantech blowers with plastic wings in dry section. | |
| 29/07-98 | 13 |
New outlet guide in dry 129183. | |
| 10/01-98 | 14 |
New switch box (217148) with automatic fuse mounted. | |
| 10/01-98 | 15 |
+ |
New motor (217209) with needle bearings in gear box. |
| 10/11-98 | 16 |
+ |
New 32T gear wheel in dry rack. |
| 05/01/99 | 17 |
Edge strip (7105) mounted in dry inlet. | |
| 12/03-99 | 18 |
Speed PCB with jumper to disengage creep speed. | |
| 22/04-99 | 19 |
+ |
Edge strip altered prior to mounting, on the bottom in dry inlet. |
| 10/11-99 | 20 |
+ |
Lower rubber lip at dry inlet fixed with rivets |
| 09-02-00 | 21 |
Wireing changed. Dryer blowers 136711, 136712 connected directly to relay PCB. Cable 217609 directly from relay PCB to pump support. Replenishment pumps in left side of machine |