Modification card for: EGP  901 on-line B1 CtF Part No.: 161470

Rev.nr.: 01 Print Date: 12-03-02

Date

 

 Lev. + Description
25-05-99 1   First series with new computercontrol placed in the receiving basket area. Other features as 161370 level 31
01-08-99 2 + Extended temperature range Dev, fix ,(wash), dry, new hard and software
10-11-99 3 + Lower rubber lip at Dry inlet fixed with rivets
03-03-00 4   CPU Board 305110 with 5 pin plug for controlpanel. Connections for conveyor in one plug.
19-04-00 5 +

Load roller  with 3 orings on top of  upper plate inlet roller in Dev1 rack
Upper inlet roller for plate in Fix 1 rack 1” PU, upper inlet roller stab+wash2 1”soft Rubber. Upper guide wash2 changed to 117588
04-05-00 6 +

Black tape on dev endplate at Feed sensor.
Lower inlet roller in dry rack changed from soft rubber to PU
22-05-00 7 + Heatsink on TIP145 powertransistor for drivemotor
22-09-00 8  

MK3 electronics
CPU 305116 Panel 305316
Software 2,0 or higher
Uses  Speedway communication
09-01-01 9 + Fuse F5 for drive motor changed to 6,3A slow part no. 8909
04-10-01 10 +

A resistor 68Kohm connected parrallel to R108 which is 10Kohm. Later R108 is changed to 8.87Kohm.
Problem were drive motor stopping occasionally  at high supply voltage. (E.g. input 237V. and  trafo connected for 208V)

back.gif (284 bytes)