| Modification card for: DOLEV 400 CONVEYOR | Part No. : 317310 |
Print Date: 12-03-02
| Date
|
Lev. | + | Description |
| 7/10-92 | 1 | Rack side
plates altered to 317511A. Lower guide 317361 altered to 317361A with new roller placing and switch moved. |
|
| 20/10-92 | 2 | Motor 317517 with 8 mm axel altered to 317507 with 4 mm axel. | |
| 6/11-92 | 3 | Dividing line
between lid and bottom lowered. Bottom 317301 altered to317301B. Lid 317331A altered to 317331B. |
|
| 21/1-93 | 4 | Alteration to buffer guide 317312B requires new roller with slits. | |
| 28/1-93 | 5 | + | Gear wheel on
motor altered from 24T to 16T. Construction diagram altered to 317310A. |
| 9/2-93 | 6 | Buffer guide
317312B replaced with 317362 and a new locking device. Locking pins on rack side plates moved. |
|
| 15/2-93 | 7 | + | Guide to be installed withen the dolev delivered with conv. |
| 17/2-93 | 8 | + | New interface
PCB. Uses cut signal. Extra wire in cabel set 317059. |
| 5/3-93 | 9 | Lid altered for easier use. | |
| 5/3-93 | 10 | Dev altered to cover the whole front of mc. | |
| 20/4-93 | 11 | Bear nuts mounted on lid, to hold cassette in place. | |
| 28/5-93 | 12 | + | Interface PCB
allows conv. switch to start mc: Time for long/short pulses adjusted to 1.9sec. |
| 7/6-93 | 13 | + | Interface PCB
allows conv. switch to start mc: Time for long/short pulses adjusted to 1.9sec. |
| 1/9-93 | 14 | Daylight cassette not standard any longer. | |
| 1/10-93 | 15 | + | Conv. connected to earth via cable. |
| 1/10-93 | 16 | Ready signal off when no feed on even in off line mode. | |
| 1/10-93 | 17 | + | Both rollers in
conv. with slits. Top guide with finger holes in slits. |
| 1/10-93 | 18 | Load switch starts mc. | |
| 6/12-93 | 19 | + | 317302 altered
to version C with a longer bottom lip. To avoid scratches guide 317411 removed. Guide from level removed. |
| 20/1-94 | 20 | + | 317302 replaced by 317402 plus a buffer guide that can tilt. |
| 15/2-94 | 21 | + | 317311 replaced by 317421. |